O&O Software DiskImage 5 Professional Edition Guía de usuario descargar pdf (Pagina 26)

Advanced features

O&O DiskImage-20

Activity window for cloning drives.

1. Select Cloning in the Ribbon bar.

2. You can set additional settings for cloning under Options.

3. Select the drive you want to clone by checking the box next to it.

4. A dialog will then appear where you must select a target drive.

5. Click Map if you want to clone additional drives or Start if you want to continue with the cloning.

6. In the following dialog under Advanced options, you can specify whether certain functions should be

executed when cloning is completed. These functions are disabled by default.

7. Once you've enabled all your settings, click Start, to begin the cloning process.

8. You can also “recopy” your clone in exactly the same fashion - to put it back on your computer/drive.

Important! When cloning your drive (source drive), the selected target drive, will be overwritten. All data stored

on it will be deleted and replaced by the clone! You should therefore save the clone on something like an external

hard disk chosen for this purpose.

Note: When cloning a drive, you should adjust the properties of the target drive for future application. Make

sure, for example, that the system partitions of the clone will also be able to boot.

Note: If you're using a second hard disk as a target, O&ODiskImage will change its signature. This will guar-

antee that there are no two hard disks with the same signature connected to your computer. There might

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 95 96

Sin comentarios

O&O Software DiskImage 5 Professional Edition Guía de usuario Pagina 26